Automatic Switch-Off; Switching Off Manually; Child Safety - Lancellotti ENFASI Manuel D'utilisation

7.6.9
The induction hob is fitted with a safety device that protects the internal electronics against
overheating. This device requires no attention from the user and enables the hob to be used
confidently without the risk of overheating.
7.6.10 Deactivating a single radiant element
On turning any knob anticlockwise and keeping it in that position for more than 30 seconds, the
relative display will show the adjacent symbol to indicate the radiant element is deactivated.
If the knob is not positioned correctly, the relative display will show error code
deactivation of the radiant element. It is not necessary to call Customer Service; to restore the
radiant element, simply return the knob to position "0" and reset the required power value.
This function is advisable to disable a single radiant element if it is faulty or malfunctioning.
After the radiant element has been repaired by the authorised Technical Support Service, it can
be reactivated by turning the knob anticlockwise again and keeping it in that position for more
than 30 seconds.
7.7
An automatic counter counts the time elapsing since the last power variation. This determines the
maximum heating duration, which varies according to the power level selected.
If a radiant element is left on by mistake (with a correctly positioned pan), it will switch off
automatically once the maximum heating duration for the selected power is reached.
SELECTED POWER LEVEL
MAX TIME IN MINUTES
7.8
Turn all the knobs to "0" position. Each display will show a flashing dot as in the adjacent figure;
after 15 seconds all the displays will switch off, a beep will be emitted and the appliance with go to
stand-by.
7.9
The radiant elements can be deactivated. Turn the first
two knobs on the left anticlockwise simultaneously and
keep them in this position for least 2 seconds, until all the
displays show symbol .
After a few minutes the symbols
radiant elements will not activate and the above-mentioned
lock symbols appear on all displays if any knob is turned.
The deactivation has no time limit. A prolonged power failure may cancel this deactivation.
To reactivate the radiant elements, turn the first two knobs on the left anticlockwise simultaneously.
Instructions for the user
Overheating

Automatic switch-off

1 2 3 4
360 360 300 300

Switching off manually

Child safety

5 6 7 8
240 90 90 90
switch off, but the
which signals
9 P
90 10
107