Section 2. Cleaner Specifications; General Specifications; Section 3. Assembly; Unpacking - Polaris 9400 Sport 4WD Manuel Du Propriétaire

Section 2. Cleaner
Specifications
2.1

general Specifications

The general specifications for the cleaner are as follows:
Control box
supply voltage
Supply voltage
installed load
Cable length
Cleaner size (WxDxh) 16.9 x 18.9 x 10.6 in.
Pack size
(WxDxh)
Weight of Cleaner
Packed weight
Filtration
Cycle lengths
The cleaner is a double-insulated product. A double-
insulated electrical appliance is one which has been
designed in such a way that it does not require a safety
connection to ground. The basic requirement for
double-insulation is that no single failure can result
in dangerous voltage becoming exposed so that it
might cause an electric shock and that this is achieved
without relying on an earthed (grounded) metal casing.
This is achieved by having two (2) layers of insulating
material surrounding live parts or by using reinforced
insulation. Therefore, devices having double-insulated
construction, such as this cleaner, do not utilize a
grounded (three-prong) cord/plug.

Section 3. Assembly

3.1

Unpacking

The packaging should contain the following items :
• Polaris cleaner
• Control unit
• Transport and storage caddy assembly components
(Figure 1)
(a) handle frame
(b) support blocks (x 2)
(c) wheels (x 2)
(d) wheel locking clips (x 2)
(e) wheel axle / hubcap (x 2)
100-125 VAC, 60 Hz
30 V DC
150 W max
60 ft (18 m)
43 x 48 x 27 cm
22.8 x 22.8 x 23.2 in.
56 x 56 x 46 cm
21 lbs. (9.5 kg)
42 lbs. (19 kg)
down to 100 microns
variable programming
(f) base unit
(g) cleaner hook
(h) caddy handle
x 2
B
A
F
Figure 1. Transport Caddy Assembly Components
When unpacking the cleaner and its components:
• Check to make sure each component is in the box.
• Check cleaner and components for damage during
transport.
• If there are any missing parts or damage, contact
Zodiac Pool Systems, Inc. at 1-800-822-7933.
3.2

Assembling the Transport Caddy

1. Unscrew the handnut from the base unit
(Figure 2).
Figure 2. Remove handnut from Base Unit
Page 5
D
C
x 2 x 2
x 2
E
h
g