Section 2. Cleaner Specifications; Section 3. Assembly And Setup; Unpacking; Assembling The Transport Caddy - Polaris P825 Manuel Du Propriétaire

Page 4

Section 2. Cleaner Specifications

Control box 100-240VAC, 60 Hz
supply voltage
Supply voltage 30 V DC
Installed load 150 W max
Cable length 50 ft (15 m)
Cleaner size 16 x 16.5 x 10 in. (41 x 42 x 25 cm)
(WxDxH)
Weight of Cleaner 20 lbs. (9 kg)
Filtration All-purpose filter canister
Cycle lengths 1.5 hr floor only; 2.5 hr floor/walls/waterline
The cleaner is a double-insulated product. A double-
insulated electrical appliance is one which has been
designed in such a way that it does not require a safety
connection to ground. The basic requirement for double-
insulation is that no single failure can result in dangerous
voltage becoming exposed so that it might cause an
electric shock and that this is achieved without relying on
an earthed (grounded) metal casing. This is achieved by
having two (2) layers of insulating material surrounding
live parts or by using reinforced insulation. Therefore,
devices having double-insulated construction, such as this
cleaner, do not utilize a grounded (three-prong) cord/plug.

Section 3. Assembly and Setup

3.1

Unpacking

The packaging should contain the following items:
• Robotic cleaner and floating power cable
• Control unit with power cord
• Transport and storage caddy assembly components
(Figure 1)
(a) handle frame
(b) support blocks (x 2)
(c) wheels (x 2)
(d) wheel locking clips (x 2)
(e) wheel axle / hubcap (x 2)
(f) base unit
(g) caddy handle
x 2
B
A
F
Figure 1. Transport Caddy Assembly Components
When unpacking the cleaner and its components:
• Check to make sure each component is in the box.
• Check cleaner and components for damage.
• If there are missing parts or damage, contact
Polaris Technical Support:
USA 1-800-822-7933
Canada 1-888-647-4004 .
3.2

Assembling the Transport Caddy

1. Unscrew the handnut from the base unit
(Figure 2).
Figure 2. Remove Handnut from Base Unit
2. Insert the metal handle frame tubing into the
base unit with notch end at the top, then rotate
so the bends are away from you. (Figure 3).
x 2
D
C x 2
x 2
E
G