Section 2. Cleaner Specifications; General Specifications; Section 3. Assembly And Initial Usage; Unpacking - Polaris P93 Guide Du Propriétaire

Section 2. Cleaner
Specifications

2.1 general Specifications

The general specifications for the cleaner are as follows:
Control box
supply voltage
Supply voltage
installed load
Cable length
Cleaner size (WxDxh) 16.9 x 18.9 x 10.6 in.
Pack size
(WxDxh)
Weight of Cleaner
Packed weight
Filtration
Cycle lengths
The cleaner is a double-insulated product. A double-
insulated electrical appliance is one which has been
designed in such a way that it does not require a safety
connection to ground. The basic requirement for
double-insulation is that no single failure can result
in dangerous voltage becoming exposed so that it
might cause an electric shock and that this is achieved
without relying on an earthed (grounded) metal casing.
This is achieved by having two (2) layers of insulating
material surrounding live parts or by using reinforced
insulation. Therefore, devices having double-insulated
construction, such as this cleaner, do not utilize a
grounded (three-prong) cord/plug.
Section 3. Assembly and initial
Usage

3.1 Unpacking

The packaging should contain the following items
(Refer to Figure 1):
• Polaris cleaner
• Control unit
• Transport and storage caddy (complete with
assembly components)
100-125 VAC, 60 Hz
30 V DC
150 W max
60 ft (18 m)
43 x 48 x 27 cm
22.8 x 22.8 x 23.2 in.
58 x 58 x 59 cm
21 lbs. (9.5 kg)
42 lbs. (19 kg)
less than 100 microns
1.30 hrs, 2.30 hrs.
Figure 1. Components
Check that the unit has not been damaged during
transport. If you detect damage, contact Zodiac Pool
Systems, Inc. at 1-800-822-7933 before using your
cleaner.
To unpack the cleaner and its components:
1. Remove the lower portion of the caddy along
with the upper and lower power cable hooks,
control unit hook, power cable hook plate,
locking plate, nuts, bolts and screws.
2 Remove the small box that contains the control
unit.
3. Remove the handles (left and right) of the
caddy, which are located against one side of the
box.
4. Remove the cleaner from the box.

3.2 Assembling the Transport Caddy

1. Insert the upper tubes (handles) into the bottom
tubes on the cart as shown in Figure 2. Make
sure the upper tubes (handles) are in the proper
orientation and align the screw holes.
1
Figure 2. install the handles
Page 5
X1
X4
X4
X1
X4
X2
X4
X2
X1
X1
X1
X1