Section 2. Cleaner Specifications; General Specifications; Section 3. Assembly And Initial Usage; Unpacking - Polaris 9100 SPORT Manuel Du Propriétaire

Page 6
Section 2. Cleaner
Specifications

2.1 general Specifications

The general specifications for the Polaris 9100 Sport
are as follows:
Control unit voltage:
Polaris 9100 Sport
supply voltage:
Installed load:
Cable length:
Weight of cleaner:
Filtration efficiency:
Cycle length:
The Polaris 9100 Sport is a double-insulated product.
A double-insulated electrical appliance is one which
has been designed in such a way that it does not
require a safety connection to ground. The basic
requirement for double-insulation is that no single
failure can result in dangerous voltage becoming
exposed so that it might cause an electric shock and
that this is achieved without relying on an earthed
(grounded) metal casing. This is achieved by having
two (2) layers of insulating material surrounding live
parts or by using reinforced insulation.
Therefore, devices having double-insulated
construction, such as the Polaris 9100 Sport, do not
utilize a grounded (three-prong) cord/plug.
Section 3. Assembly and initial
Usage

3.1 Unpacking

The packaging should contain the following items
(Refer to Figure 1):
• Polaris 9100 Sport robotic cleaner
• Control unit
• Hardware and template
• Owner's Manual
100-240 VAC, 50/60 Hz
30 V DC, max.
70 W max
50 feet
15 m
12 lbs
5.75 kg
fine filtering
2 hours approx
Check that the unit has not been damaged during
transport. If you detect damage, contact Zodiac Pool
Systems, Inc. at 800.822.7933 before using your Polaris
9100 Sport robotic cleaner.
Control Unit
Figure 1. polaris 9100 Sport Components
To unpack the Polaris 9100 Sport and its components:
1. Open the top flaps of the carton.
2 Remove the control unit from the carton.
3. Remove the floating cable and then the cleaner
from the carton.
3.2 Attaching the Control Unit to a Wall
1. Place the template, provided with the unit, on
the wall where you want to attach the control
unit.
2. Using the 1/8" drill bit, drill three (3) holes.
Screw the three (3) 1/4" screws, provided with
the unit, into the holes and place the control
unit onto the screws. Refer to Figure 2.
Figure 2. position Control Unit on the Wall
Cleaner
Floating Cable