Section 4. Operation; Submerging The Cleaner; Operating The Cleaner - Polaris 9300xi Sport Manuel Du Propriétaire

Section 4. Operation

4.1 Submerging the Cleaner

1. Submerge the cleaner in the pool and remove any
air trapped inside by keeping the unit vertical.
Refer to Figure 13.
1
Figure 13. Submerge the Cleaner Vertically
2. Ensure the unit sinks to the bottom of the pool.
Refer to Figure 14.
2
Figure 14. Cleaner on the Bottom of the Pool
3. Spread out the fl oating cable over the pool,
ensuring there are no kinks or coils in the cable.
Refer to Figure 15.
Figure 15. Spread Floating Cable Over the Pool

4.2 Operating the Cleaner

1. Plug the control unit into a GFCI protected power
source.
Select either the Cycle I or Cycle II cleaning
program on the control unit:
Cycle I Program
• Completed in 1.5 hours
• Maximum coverage in
minimal time
2. To start your 9300xi Sport cleaner, press the button
for "Cycle I" cleaning program. "Cycle I" cleaning
is the primary cleaning cycle for inground pools.
3. When the "Cycle I" program button is selected the
indicator light above will illuminate. The cleaner
will start in a few seconds.
Figure 16. Start the Cleaner
4. Depending on the state of your pool it is possible
to modify the time of the cleaning cycle by
pressing the button. Pressing the
will increase the cleaning time by 60 minutes or
decrease the cleaning time by 30 minutes. When
the cleaner is powered on, the Cycle and time will
correspond to the cycle and the time that were
active at the time it was last switched off.
5. If you wish to stop the cleaner during a cleaning
cycle, press the "Power" button. Refer to Figure 17.
Figure 17. Turn Cleaner Off
Page 9
Cycle II Program
• Completed in 2.5 hours
• Intensive and complete
cleaning
• Thorough tile cleaning
button