Reset The Phone; Troubleshooting - Topcom BUTLER E600 TWIN Manuel D'utilisateur

Reset the phone

9 Reset the phone
It is possible to return the phone to the original default configuration. This is the configuration which
was installed when you first received the telephone. After the reset all your personal settings and
call list entreis will be deleted, but you phonebook remains.
To return to default settings:

10 Troubleshooting

Symptom
No display
No tone
The icon flashes
Base or handset do not
ring
Not possible to transfer a
call on PABX
Telephone does not react
when pressing the keys
30
1 Enter the menu by pressing the left menu key.
2 Select "DEFAULT" and confirm.
3 Enter the 4-digit system PIN and confirm.
4 Confirm again.
Possible cause
Batteries uncharged
Handset turned off
Telephone cord badly connected
The line is occupied by another
handset
Handset out of range
The base has no power supply
The handset is not registered on
the base
The ringing volume is off or low
The flash time is too short or too
long
Manipulation error
Solution
Check the position of the batteries
Recharge the batteries
Turn on the handset
Check the telephone cord
connection
Wait until the other handset hangs
up
Bring the handset closer to the base
Check the mains connection to the
base
Register the handset on the base
Adjust the ringing volume
Change the flash time
Remove the batteries and put them
back in place