Important Safety Instructions - Brandt DVDP-10R Manuel D'instructions

IMPORTANT SAFETY INSTRUCTIONS

This equipment is designed to operate from a
50/60Hz AC mains supply. Other power sources may damage it.
Check that the voltage marked on the rating plate on the power
adapter is the same as your mains supply.
If the power adapter becomes damaged, it should be replaced with
an adapter of the same type and rating to avoid a hazard.
If the incorporated battery starts to leak or becomes too hot during
operation or charging, please stop operation immediately and
dispose of the unit.
The marking plate is located at the bottom of the apparatus.
Symbols
This equipment is
double insulated and
an earth connection is
not required.
Dangerous voltage
constituting a risk of
electric shock is
present inside this
equipment.
Battery handling and usage
Remote control battery:
The battery should only be replaced by adults. Do not allow children to
use the remote control unless the battery cover is attached.
The battery type used in the remote is one CR2025 3V
Lithium battery which is accessible and can be replaced.
Remove the battery holder located on the bottom of the
remote control to remove the battery.
100 240 Volt,
This mark is applied to
show the equipment
conforms to European
safety and electromagnetic
compatibility standards.
There are important
operating and maintenance
instructions in the literature
accompanying this
equipment.
EN-3