Instructions for installation and use
4.7. Installation of the bench
After the control unit has been connected, the bench can be fully installed.
Fig. 45: Attaching the bench
Place the bench on the support slats. Push the seating areas forward.
CAUTION!
Secure the bench against sliding by using the locking screws on the
left and right of the bench cushion as well as on the bench support rail.
4.8. Installation of spacer strips of the rear wall
Screw the spacer strips to the rear wall (either flush or displaced inwardly up to
10 cm).
Fig. 46: Installation of the spacer strips of the rear wall
Screws
4 units: 4 x 70
Screws
4 units: 4 x 70
p. 36/40