Black & Decker BDH1855SM Manuel D'instructions page 8

cautIon:
sWItchInG on/off - fig. n
notIce:
When the steam mop is first turned on the
water reservoir will glow red. Once the steam mop is
ready to use the water reservoir will glow blue. It takes
approximately 15 seconds for the steam mop to heat up.
• To switch the appliance on, press the ON/OFF button (1).
• To switch the appliance off, press the ON/OFF button.
notIce:
Never leave the steam mop in one spot
on any surface for any period of time. Do not store with
a wet pad as this can damage your floor. always place the steam mop with the handle (4) in
the upright position when stationary and make sure the steam mop is turned off when not in
use.
notIce:
always empty the water tank after use.
smartselect
tM
The steam mop is equipped with a SmartSelect
floor surface cleaning applications. a light will glow next to the selected application. To
change the application, press and release the SmartSelect
glows next to the correct operating mode for your particular hard floor surface.
notIce:
Do not use on any unsealed hard floor surfaces. additionally, on
surfaces that have been treated with wax or some no wax floors, the sheen may be
removed by the heat and steam action. It is always recommended to test an isolated
area of the surface to be cleaned before proceeding. We also recommend that you
check the use and care instructions from the floor manufacturer.
using the smartselect
The steam mop will select the correct volume of
steam required for your particular cleaning operation.
notIce:
smartselect
previously used setting.
steaM Burst Button
The steam burst button is a built in feature that aides in the removal of stubborn floor marks or
stuck on grime.
• To apply an extra burst of steam to trouble areas, press the Steam Burst button (23).
notIce:
The steam burst will last for 10 seconds then the steam mop will return to
the chosen setting.
notIce:
This unit will kill 99.9% of bacteria and germs when used in accordance with
this manual and with the micro fiber pad fitted and a continuous run time of 90 seconds.
GeneraL use
cautIon:
WarnInG:
water tank and continue to sanitize/ clean, see Filling the Water Tank section.
notIce:
Never leave the steam mop in one spot on any surface for any period of time.
oPeratIon
for fLoor use onLy; do not use the unIt uPsIde doWn.
dial - fig. o
button (2), choose from one of the following applications:
tM
tM
has a memory. Switching the steam mop on will recall the
hInts for oPtIMuM use
Never use the steam mop without first attaching a cleaning pad.
It is important to monitor the water level in the water tank. To refill the
n
dial (28) which shows various hard
TM
button (2) until the light
TM
o
2
28
8
23