Black & Decker BDH1855SM Manuel D'instructions page 5

notIce:
each steam mop is 100% tested in the factory to ensure product
performance and safety. When assembling your new steam mop for the first time you may
notice water residue inside of the unit.
WarnInG:
appliance is switched off and unplugged and that the appliance is cold and contains
minimal or no water.
attachInG the handLe - fig. B
• With both cord hooks (26 & 27) facing the back, slide the
bottom end of the handle tube (4) into the top end of the
steam mop body (11) until it is firmly seated and clicks
into place.
attachInG the steaM head - fig. c
• Slide the bottom end of the steam mop body (11)
onto the steam head (5) until it clicks into place.
• The steam head can be removed from the steam
mop body by pressing the steam head release
button (12) and pulling the steam mop body off the
steam head.
attachInG the handheLd steaM
cLeaner - fig. d
• Push the hand-held steam cleaner (3) firmly into the
steam mop body (11) until it clicks into place.
reMoVInG the hand-heLd steaM
cLeaner - fig. e
• Push the release button (13) down and pull the hand-held
steam cleaner (3) away from the steam mop body.
asseMBLy
Before attempting any of the following operations, make sure that the
B
c
d
e
5
26
4
27
11