Starting The Engine - SWM Six Days 2021 Guide Rapide

Six Day
INSTRUCTIONS FOR USING THE
MOTORCYCLE

STARTING THE ENGINE

After getting on the motorcycle as described in
the relative paragraph, operate as follows to start
the engine:
1) Place ignition key (1) to position (the buzz
that you hear when you turn the key to
caused by the fuel pump which puts the feeding
system under pressure);
2) pull the clutch lever (2);
3) shift gear pedal (3) to neutral position then
release the clutch control level;
4) check that the button (4) is in
then press the start button (5).
WARNING*:
Do not run the cold motor with a high number
of revs.
12 / EN
Note*: A safety switch is set on the clutch lever
support. This switch allows you to ONLY start the
engine with the gearbox idle, or with the gear
engaged and the clutch lever pulled.
With the stand lowered, the bike can only be
started with the gear in neutral.
is
position and
1
N
2
3
4
5