IMG STAGELINE TXS-606 Mode D'emploi page 10

the transmitter and the receiver are set to the
GB
same channel.
5) After the receiver and the transmitter have been
set to the same transmission channel, the
antenna symbol
right of the display of the receiver (symbol on the
left = left antenna receives the most powerful
signal). If no antenna symbol appears, please
check:
a Are the batteries of the transmitter ex -
hausted?
b Is the reception disturbed by metal objects in
the transmission path?
c Is it possible to improve the reception when
you turn the receiving antennas?
d Is the distance between the transmitter and
the receiver too long?
e Has the interference suppression been set
too high with the control SQUELCH (11)?
( chapter 4.4)
4.3 Setting the line output level
To match the output level of the jack LINE OUT (12)
to the input of the subsequent unit:
1) Switch on the subsequent audio unit or advance
the corresponding control of the mixer.
2) Press the button SET three times so that the
numerals for VOL start flashing.
3) Speak / sing into the microphone. While the
numerals keep flashing (a few seconds after
pressing the button SET,
level with the button
00 – 63].
Note: If the numerals stop flashing before you have set
the output level, press the button SET three times
again.
4) Once the numerals stop flashing, the setting has
been stored.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
10
appears on the left or on the
or ), set the output
or (5) [setting range
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
4.4 Setting the interference suppression
With the control SQUELCH (11), adjust the thresh-
old value for response of the interference suppres-
sion. The interference suppression will mute the
receiver during pauses in speech or vocals when
interfering signals are received and their levels are
below the threshold value adjusted. A high thresh-
old value, however, will also reduce the range of
the microphone system: If the power of the radio
signal falls below the threshold value adjusted, the
receiver is also muted. Therefore, adjust a high
threshold value (turn the control towards MIN)
when the reception is good and a low value (turn
the control towards MAX) when the distance
between the transmitter and the receiver is long.
5 Specifications
Carrier frequencies: . . . . 672.000 – 696.975 MHz
RF S / N ratio: . . . . . . . . . 105 dB
Audio frequency range: . 30 – 18 000 Hz
Dynamic range: . . . . . . . 120 dB
THD: . . . . . . . . . . . . . . . . < 0.5 %
Audio outputs
MIC OUT: . . . . . . . . . . 25 mV, 600 Ω, XLR, bal.
LINE OUT: . . . . . . . . . 350 mV, 600 Ω,
Power supply: . . . . . . . . via power supply unit
Ambient temperature: . . . 0 – 40 °C
Dimensions: . . . . . . . . . . 212 × 45 × 180 mm
Weight: . . . . . . . . . . . . . . 930 g
Subject to technical modification.
for channels see table
on pages 24 / 25
6.3 mm jack, unbal.
provided and connected
to 230 V~ / 50 Hz