To Top Up Hydraulic Oil; Storage - Gesipa TAUREX 1 Axial Mode D'emploi

GB
9.3

To top up hydraulic oil

Follow correct sequence!
Wear safety goggles!
• Disconnect the riveting tool from the compressed air supply.
• Remove the hanger (I) from the riveting tool.
• Remove oil screw plug with seal (G and H) and screw the supplied oil refill reservoir into
the thread.
• Unscrew steel head sleeve (B) and push grip mechanism by hand as far as it will go into
the tool head.
• Hang up the tool head by the handle. Make sure that there are no loops in the hydraulic
hose, with a constant incline from the air cylinder to the tool head.
• Remove oil screw plug with seal (J and K) and screw supplied filling adapter into the
thread.
• Fit oil can with pump mechanism (not included in scope of delivery) into the free end of
the filling adapter hose.
• Pump hydraulic oil into the tool until the oil refill reservoir at the tool head is approximate-
ly half full.
• Lower the tool head to the same level as the air cylinder and remove the oil refill reser-
voir. Screw in the oil screw plug together with seal (G and H) and tighten.
• Unscrew filling adapter then screw in the oil screw plug together with seal (J and K) and
tighten.
• Connect riveting tool to compressed air supply.
• Carefully undo oil screw plug (G) by 2 turns; the grip mechanism moves slowly into the
front end position. Collect leaking oil in a rag.
• Tighten oil screw plug (G).
• Screw on steel head sleeve (B).
Regular maintenance will extend the service life of your high-quality GESIPA
and they should be serviced at least every 2 years by an authorised workshop or by
GESIPA Service. We recommend servicing tools that are subject to intensive use
®
ahead of schedule.
9.4

Storage

The blind rivet setting tool should be stored in a dry place where there is no danger of frost.
20
Danger of oil escaping at high pressure.
tools
®