Safety Notes; Important Notes; Lubrication; Functions - LGB 69576 Mode D'emploi

Safety Notes

• This model may only be used with the operating system designed for it.
• Use only switched mode power supply units and transformers that are designed
for your local power system.
• This locomotive must never be supplied with power from more than one power pack.
• Pay close attention to the safety notes in the instructions for your operating system.
• Not for children under the age of 15.
• The LEDs in this item correspond to Laser Class 1 according to Standard EN 60825-1.
• WARNING! Sharp edges and points required for operation.
• WARNING! This product contains magnets. Swallowing more than one magnet may
cause death in certain circumstances. If necessary, see a doctor immediately.

Important Notes

• The operating instructions are a component part of the product and must therefore
be kept in a safe place as well as included with the product, if the latter is given to
someone else.
• The warranty card included with this product specifies the warranty conditions.
• Please see your authorized LGB dealer for repairs or spare parts.
• Disposing: www.maerklin.com/en/imprint.html

Functions

• This model is designed for operation on LGB two-rail DC systems with conventio-
nal LGB DC train controllers or power packs (DC, 0 – 24 volts).
• Only for analog operation

Preparation

It may be possible that the coupler on the locomotive has to be adapted to the tender.
To do this, replace the coupler loop installed at the factory with the coupler hook
included with the tender (Figure 1).
Connecting Cable
The tender should be connected to the general-purpose socket on an LGB locomotive
in order to increase operating reliability. A connecting cable is included for this
purpose. Plug the connecting cable into the general-purpose socket on the front of
the tender and into the socket on the rear of the locomotive (Figure 2).
Electronic Sound
Steam Sounds: The chuffing for this model depends on the voltage present in the
rails, not on the speed of the tender. The chuffing will become faster when you
increase the voltage.
Bell and Whistle: The bell and whistle can be activated with the LGB sound activa-
tion magnets (17050) included with the tender. The activation magnet can be clipped
between the ties on most sections of LGB track. The magnet is located off center
under the imprinted LGB logo. Place the magnet on one side to activate the whistle
when the tender crosses over this spot. The bell will sound when you place the
magnet on the other side.
General Note to Avoid Electromagnetic Interference:
A permanent, flawless wheel-rail contact is required in order to guarantee operation
for which a model is designed. Do not make any changes to current-conducting parts.
SERVICE

Lubrication

Oil the axle bearings now and then with a drop of Märklin oil (7149).
4