Assembly Steps - Lenze ECSDK Serie Instructions De Montage

Mounting with thermal separation (push−through technique)
3.2.2

Assembly steps

How to mount the capacitor module:
1. Prepare the mounting holes for the wire clamps on the mounting surface.
–
Apply a drilling jig for this purpose.
2. Prepare mounting cutout.
–
The edges of the mounting cutout and the mounting holes for the wire
clamps must be slightly curved to the inside (to the capacitor module).
3. Fasten the wire clamps.
–
Seal the screws for the wire clamp with liquid thread seal (e.g. Loctite 620).
4. Push the capacitor module into the mounting cutout.
5. Snap the capacitor module in the wire clamp at the top and bottom.
EDKCSDK002 DE/EN/FR 1.1
Mechanical installation
l
Assembly steps
3
51