Medela Calesca Mode D'emploi page 11

Warming mode
8
9
10
11
12
Press On/Off button
LCD display to confirm the device is in WARM
NOTE: The device defaults to warm mode.
Select the milk starting temperature (refrigerated, room, or
frozen) by using the arrow keys
starting temperature.Press the enter button
starting temperature.
NOTE: The device initially defaults to the milk starting tem-
perature (symbol refrigerated) (refrigerated) based on 4 ˚C or
39.2 ˚F.
Use the arrows to enter the volume of milk to be warmed.
Press the enter button
NOTE: If you hold down the left or right arrow key, it will
decrease or increase in increments of 10 mL.
The LCD display will flash the information that was entered
into the device and display the completion time. Confirm that
the information is correct and press the start button
begin warming.
NOTE: If the information is incorrect, press the stop button
and repeat programming steps above.
stop
There are two timers located on the LCD display. The lower
left display will show the total cycle time and will count down
to zero. The upper left display shows the total elapsed time
the breast milk or supplement has been in the device.
If the lid is opened during the warming cycle, the unit will go
into a pause mode for 60 seconds. The visual indicator on
the front of the unit will flash orange. If the syringe or con-
tainer is placed back into the unit, the start button
be pressed, and the cycle will continue to completion. If the
60 seconds is exceeded, the unit will stop and reset.
NOTE: Open the lid to activate pause mode while using a
syringe.
to turn on the device. Look at the
/ to highlight the desired
to confirm volume.
enter
mode.
to confirm
enter
to
start
can
start
11
EN