Manual Lighting Procedure; Shutting Off Your Grill - Pit Boss PB2BPGG Manuel De L'utilisateur

MANUAL LIGHTING PROCEDURE

1. Open lid during lighting.
2. Set all control knobs to the "OFF" position.
3. Open the cylinder/gas valve according to the operating
instructions on tank.
4. Quickly and carefully, use a lit match secured with the lighting
rod (included with the grill) to light the burner. Gain access to
the burner through the cooking grids. Position lit match near
side of burner. Do not attempt to light another area of the
burner. This can cause injury.
NOTE: Do not use spirit, lighter-fluid or kerosene for
lighting or refreshing a fire in your gril.
5. If the burner does not light within 5 seconds, turn burner
control knob to "OFF", wait 5 minutes, and repeat lighting
instruction. After lighting, observe the burner flame. Make
sure all burner ports are lit and flame height matches
illustration shown previously. Replace the Cooking Grid back
into position, and you are ready to enjoy your grill at your
desired temperature!
NOTE: Each burner lights independently - repeat same steps for other burners.
WARNING: Never lean over the cooking area while lighting your gas grill. Keep your face and body a safe
distance (at least 457 mm / 18 inches) from the cooking grid surface when lighting your grill by match.
6. If the above points do not work, see Troubleshooting.

SHUTTING OFF YOUR GRILL

1. When finished cooking, turn LP gas cylinder valve to the CLOSED position, and allow the regulator knob to pop out. This
safety feature locks the regulator knob to ensure that the gas is no longer flowing.
2. Turn control knobs to the OFF position.
NOTE: A "poof" sound is normal as the last of the LP gas is burned.
3. Disconnect LP gas cylinder by following the Disconnect LP Gas Tank instructions.
WARNING: Allow the grill to cool completely, and remove the gas cylinder, before moving, travel, or for
storage.
11