Operation; Remote Control - Pelgrim OSWA0980 Serie Notice D'utilisation

OPERATION

Remote control

Operation
EN 6
Connecting the remote control to the appliance
If the appliance cannot be operated with the remote control, e.g. after
the battery has been changed, the connection between the remote
control and the appliance must be re established.
1. Press and hold the '+' button.
2. Attach the appliance to the mains voltage.
▷ A long audible signal sounds. The remote control has been
connected to the appliance.
Note: If no audible signal sounds within 30 seconds, repeat this
procedure.
Switching on the extraction
1. Press the '+' button.
▷ The extraction starts at level 2.
▷ On the led status bar the lighting of level 1 and 2 comes on.
Adjusting the extractor capacity
1. Press (several times) the '-' or '+' button to select a higher or lower
setting (0-1-2-3-P).
▷ The maximum setting you can select is the intensive setting P
(setting 4). On the led status bar the lighting of level 1, 2 and 3
comes on and setting P is blinking.
▷ The run time of the intensive setting is 4 minutes. Once this time
has elapsed, the fan switches to level 2.
Switching off the extraction
1. Press the off button.
▷ The extraction switches off.
Switching the lighting on and off
1. Press the lighting button.
▷ The lighting comes on.
2. Press the lighting button again and the lighting fades to off.