Fans Cleaning; Gasket Replacement; Trouble Shooting - Cadel Nice Manuel D'installation Et Utilisation

7.10. FANS CLEANING

Once a year clean the room fan and fumes fan to remove ash or dust which unbalance the blades and
make them noisier (see
expert.

7.11. GASKET REPLACEMENT

If the silicone gasket (18) of the stove door or fumes chamber cover have deteriorated, replace them.
Remove the gasket from its seat and replace with an original spare.

8. TROUBLE SHOOTING

(ATTENTION: before start-up tests and/or repairs check that the electronic circuit board parameters
correspond with the check list held by the after-sales service engineer).
PROBLEM
Control panel
not turns on
Stove not igniting.
Alarm on display
"AlAr no FirE"
Alarm on display
"no Acc"
Pellets not reaching
combustion chamber
Fire extinguishes
and stove stops
Stove working
Display shows "Stop
FirE"
MIRIAM-NICE-DIANA-PRETTY-MARY
Picture 16, page 87). As this is a very delicate operation, have it done by an
CAUSE
Stove without power supply
Circuit board protection fuse burnt
out
Faulty control panel
Faulty flat cable
Faulty electronic circuit board
Hopper empty
Burn pot has not been cleaned
Probe has not reached ignition
threshold
Faulty ignition spark plug
External temperature too low
Damp pellets
Heat probe blocked
Faulty electronic circuit board
Hopper empty
Auger clogged by foreign object
(e.g. nails)
Auger gear motor broken down
Check for active alarm on display
(Alar dep, Alar sond.)
Hopper empty
Auger clogged by foreign object
(e.g. nails)
Low quality pellets
Value set on circuit board for stage 1
too low
Check for active alarm on the display
(Alar dep, Alar Sond)
Burn pot dirty
SOLUTION
Check that plug is plugged into mains.
Replace board protection fuse.
Call an expert.
Replace control panel display.
Call an expert.
Replace flat cable.
Call an expert.
Replace electronic circuit board.
Call an expert.
Fill hopper
Clean burn pot: see paragraph 7.5, page 80
Empty burn pot and light again; if problem
persists call an expert
Replace ignition heating element.
Call an expert.
Start stove again.
Pellets must be stored in a dry place, check.
Replace fumes probe.
Call an expert.
Replace electronic circuit board.
Call an expert.
Fill hopper.
Unplug, remove hand protection in the hopper,
empty, clean auger and re-start.
Replace 5RPM gear motor.
Call an expert.
Have an expert inspect stove to find the causes.
Fill hopper.
Unplug, remove hand protection in the hopper,
empty, clean auger and re-start.
Try using other types of pellets.
Have an expert regulate pellet delivery.
Have an expert inspect stove to find the causes.
The stove operating
extraction on maximum, no problem.
.
on minimum, fumes
Pag. 83