Installation Of Controllers - Gree GTHCA-K6DNA1A/I Mode D'emploi

Floor Ceiling Type Unit
(5). Electric wiring of indoor unit side
Remove the left cover plate and the electric box cover then insert the end of the
communication cord and the power cable into the terminal board.
. Tighten the power cord respectively on the terminal boards with screws. Faulty
①
connection may cause a fire.
.
② If the power supply are wired incorrectly, the air conditioner may be damaged.
. Connect the indoor unit connection cord properly based on the corresponding marks as
③
shown in Fig. 29.
. Ground both the indoor and outdoor units by attaching a ground wire.
④
. Unit shall be grounded in compliance with the applicable local and national codes.
⑤

6 Installation of Controllers

Refer to the Installation Manual of the controller for more details.
Fig. 30
CAUTION!
29