Indoor Unit Installation - Gree GTHCA-K6DNA1A/I Mode D'emploi

Model
GTH(09)CA-K6DNA1A/I
GTH(12)CA-K6DNA1A/I
GTH(18)CA-K6DNA1A/I
GTH(24)CB-K6DNA2A/I
5.1.2 Preparation for Installing the Indoor Unit
(1). Open the air inlet grille and the screw cover, and remove the screws.
(2). Release the claws in the 3 places indicated.
(3). Release the center hook and remove the front panel.
(4). Release the claws in the 2 or 3 places indicated and remove the electric
component cover.

5.1.3 Indoor Unit Installation

(1). Determine the location of the hanger through the paper template, and then
remove the paper template.
(2). Insert the anchor bolts into the drilled holes, and drive the pins completely
into the anchor bolts with a hammer.
(3). Remove the right and left side panels.
(4). Put the hanger bolt into the clasp of the indoor unit and tighten screws on
the hanger to prevent the indoor unit from moving.
Table 4
A B
870 235
1200 235
Fig. 4
14
Floor Ceiling Type Unit
C D
812 318
1142 318
Unit: mm
H
665
665