Table des Matières
Publicité
INSTALLATION
Regency
These venting systems, in combination with the P42 Direct Vent Gas
Fireplace, have been tested and listed as a direct vent heater system
by Warnock Hersey. The location of the termination cap must conform to
the requirements in the Vent Terminal Locations diagram in the "Exterior
Vent Termination Locations" section.
®
Regency
Direct Vent (Flex) System Termination Kit (Part # 946-515)
includes all the parts needed to install the P42 with a maximum
run of 4 feet.
6-7/8"
(173mm) dia.
Flue pipe
If longer runs are needed, the Regency
# 946-516 includes all the parts needed to install the P42 with a
maximum 10' run.
1) 6-7/8" dia. fl exible liner (10 ft. length)
2) 4" dia. fl exible liner (10 ft. length)
3) spring spacers (7)
4) thimble (2)
5) AstroCap termination cap (1)
6) screws (12)
7) tube of Mill Pac (1)
8) plated screws (8)
9) screws #8 x 1/2" Drill Point, stainless steel (4)
12
®
Direct Vent System (Flex) Horizontal Terminations Only
Wall Thimble (2 pc)
4" (102mm)
dia. flue pipe
®
Direct Vent system (Flex)
VENTING
1) 6-7/8" dia. fl exible liner (4 ft. length)
2) 4" dia. fl exible liner (4 ft. length)
3) spring spacers (4)
4) thimble (2)
5) AstroCap termination cap (1)
6) screws (12)
7) tube of Mill Pac (1)
8) plated screws (8)
9) screws #8 x 1/2" Drill Point, stainless steel (4)
spring
spacer
Note:
a) Liner sections should be continuous without any joints or seams.
b) Only Flex pipe purchased from Regency
Installations.
®
Regency
P33E-4 Foyer à évent direct à dégagement zéro
AstroCap
Termination Cap
Part #946-523/P
®
may be used for Flex
Publicité
Table des Matières
