Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(3) First pull the Trigger.
Next, depress the Push Lever against the workpiece.
□ THE STAPLER MUST NOT OPERATE.
(4) Without touching the Trigger, depress the Push Lever
against the workpiece.
Next, pull the Trigger.
□ THE STAPLER MUST OPERATE.
(5) If no abnormal operation is observed, you may load
staples and caps in the Stapler.
Drive staples into the workpiece that is the same type
to be used in the actual application.
□ THE STAPLER MUST OPERATE PROPERLY.
ADJUSTING AIR PRESSURE
● Do not exceed 120 psi (8.3 bar 8.5 kgf/cm
Adjust the air pressure at recommended operating
pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm
according to the length of staples and the hardness of
workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Stapler at a higher than required air
pressure unnecessarily over stresses the Stapler.
LOADING STAPLES
● When loading staples into Stapler,
1) do not pull trigger;
2) do not depress push lever;
3) disconnect air hose from stapler; and
4) keep Stapler pointed downward.
WARNING
WARNING
(1) Pull the staple feeder backward, and confi rm that
the feeder stopper is securely lodged in the feeder
stopper hole on the staple feeder.
Staple feeder
(2) Place the staple strip over the magazine.
Make sure that the staple strip slides freely on the
magazine.
).
2
)
2
(3) Pull the staple feeder backward slightly, and press in
the feeder stopper. Push the staple feeder forward.
Gently set the staple feeder to the back of the loaded
staples.
The Stapler is now ready to operate.
CAUTION
If the staple feeder is released all of a sudden, it
can return abruptly, causing deformation and/or
scatter, eventually ending up in clogged staples.
Be absolutely sure to bring back the staple
feeder, avoiding any impact.
English
Feeder stopper
Staple
Magazine
Feeder stopper
2
1
3
Staple feeder
15
Publicité
Table des Matières
