LiftMaster STAR 450-390 Guide Rapide page 3

PROGRAMMING
Blocking (Unblocking) a Remote Control: To block or unblock a user.
Duplicating Memory: Allows user to backup programmed remote
control memory into the provided backup memory module.
NOTE: If two memory modules are installed, press ✱,6 to duplicate
the memory and remove the backup module.
* 6
,
PRESS SIMULTANEOUSLY
NOTE: To duplicate memory, plug backup memory module into
backup slot and press ✱,6. Once duplication is complete, remove
the backup memory module and store in a separate location.
Restoring Memory: To restore memory, simply place the duplicate
memory module in the main memory position.
ADVANCED FUNCTIONS
For advanced functions, press and hold the ✱ key and a
number key at the same time to select the corresponding
advanced function. (See table at right for available functions.)
Press the # key to exit the function.
AUDIBLE DIAGNOSTICS
NOTE: The receiver will beep if it receives a signal
from an unprogrammed remote control. The
"Audible diagnostics OFF/ON" feature will disable
the beeper, however, the beeper will remain active
for all other functions.
Step 1. Activate remote control.
Step 2. Listen for beep.
(LED will be displayed when OFF)
KEYPAD SOUND ALERTS
Single Beep: Key pressed.
Double Beep: Confirmation of an accepted Tx or
REMOTE CONTROL LOCATION QUERY
Enter a remote control location number (001-450) to view location
status (see table to the right for possible status displays).
Blc
002
2
Block
PRESS ENTER LOCATION (1-450)
dup
END
~6 SECONDS
valid add/block input.
Blc
234
023
3 4
Block
PRESS
(UNBLOCK)
TO
CONFIRM
Memory location of last remote control received.
1
*
# of open remote control locations.
2
*
# of locations occupied.
* 3
# of blocked remote control locations.
* 4
First blocked remote location.
* 5
Next blocked location (Repeat to scroll).
5
Duplicate memory- See Duplicating memory.
6
*
Version #
* 7
#
Press to exit functions.
Audible diagnostics OFF/ON (LED will be displayed when OFF)
0
*
* If no remote controls are programmed into the STAR450, then (---) will be displayed.
Double Beep: Remote control is valid and programmed into
STAR450 accompanied by remote control location
display.
Slow Beep: Security
STAR450).
Long Beep: Blocked remote control.
No Beep: Remote control not working.
Triple Beep: Confirmation of delete.
Long Beep: Blocked Tx, error, or out of range
Display
OPn Remote control location is empty
Occ
Remote control location is occupied
Blc Remote control location is blocked
Out
Remote control location is out of
range(not between 1 & 450)
3
END
Un- Blc
Main Memory Module
Backup Memory Module
+
® Remote control (Not programmed in
Description Beeper
no beep
no beep
no beep
long beep