Technical Specifications - STEINEL PROFESSIONAL IS 3360 KNX Mode D'emploi

For information on making claims under the terms of the warranty, please go to
www�steinel-professional�de/garantie
G B
If you have a warranty claim or would like to ask any question regarding your
product, you are welcome to call us at any time on our Service Hotline
1
Y E A R
01733 366700.
MANUFACTURER'S
WARRANTY
10� Technical specifications
IS 3360 KNX
IS 3180 KNX
IS 3360 MX KNX
Dimensions
Surface-mounted installation, round
(L × W × H)
Surface-mounted installation, square
Concealed installation, round
Concealed installation, square
Power supply KNX bus voltage, 21 V - 30 V
Settings via ETS software, remote control or BUS
Sensor system
Angle of 180° with 90° 360° with 180°
coverage angle of
aperture
Reaches Basic IS 3360 KNX
setting 1:
max. 8 - 20 m
tangential;
temperature-
temperature
stabilised
IS 3360 MX KNX
Basic max. 18 m;
setting 2: temperature-
max. 4 - 8 m;
temperature
stabilised
+ precision + precision
adjustment by adjustment
re-positioning using shrouds
the lens and
using shrouds
Switching
448
zones
Twilight setting 2 - 1000 lux, teach
5
3
Y E A R Y E A R
MANUFACTURER'S MANUFACTURER'S
WARRANTY WARRANTY
IS 345 KNX IS 345 MX KNX
126 × 65 mm
95 × 95 × 65 mm
124 × 78 mm
94 × 94 × 78 mm
(SELV)
Passive infrared
180° with 45° 180° with 45°
angle of angle of angle of
aperture aperture aperture
max. 20 × 4 m max. 30 × 4 m
max. 20 m (tangential), (radial)
tangential; max. 12 × 4 m mounted at a
(radial); height of 14 m;
stabilised temperature- temperature-
stabilised stabilised
stabilised
+ precision + precision
adjustment
adjustment
using shrouds using shrouds
1416 280
28
Twilight setting,
basic brightness
IP rating
Temperature
zone
Light output
Light 1 – Light 2
Further
outputs
11� Disposal
Electrical and electronic equipment, accessories and packaging must be recycled in
an environmentally compatible manner.
Do not dispose of electrical and electronic equipment as domestic waste.
EU countries only:
Under the current European Directive on Waste Electrical and Electronic Equipment
and its implementation in national law, electrical and electronic equipment no longer
suitable for use must be collected separately and recycled in an environmentally
compatible manner.
12� Troubleshooting
Malfunction
No power at the sensor
Sensor will not switch
ON
120
IS 3180 KNX IS 3360 KNX IS 345 KNX
IS 3360 MX KNX
2 - 1000 lux, teach
Surface-mounted: IP54
-20°C to +50°C
Switching, dimming, basic brightness
In-operation telegram
Cause
Break in wiring
Fuse faulty; not switched
ON; break in wiring
Short-circuit
Twilight setting in
night-time mode during
daytime operation
Lamp faulty
Mains switch OFF
Fuse faulty
Detection zone not
correctly adjusted
29
IS 345 MX KNX
Concealed: IP20
Remedy
Check KNX power supply
New fuse, turn ON power
switch, check wiring with
voltage tester
Check connections
Reset
Replace lamp
Switch ON
Replace fuse, check
connection if necessary
Readjust