Getting Started
Mounting viewers
to a wall outlet
PLAYER
compartment
RECORDER
compartment
You can mount two Picture MD Photo Viewers (MPS-
V500/V500P) on the unit and supply the power to
them. Mount the viewer(s) in the RECORDER and/or
PLAYER compartment(s) according to your needs.
Viewer
Playback
compartment
Yes
RECORDER
PLAYER
Yes
Before mounting a viewer
Remove the battery pack and the cover on the STATION
terminal from the viewer.
Remove the battery pack.
You can keep the STATION terminal cover attached to the hooks
on the rear of the viewer compartment cover.
Note
The unit and the viewer are not turned on even if the VIEWER
ON/OFF key on the unit is pressed, unless the viewer is locked
onto the unit. Be sure to slide the LOCK knob fully to the left.
6
(EN)
Getting Started
All manuals and user guides at all-guides.com
Power cord
(supplied)
AC IN
Main power
switch (MPS-
VS500P only)
VIEWER ON/
OFF
Audio
Disc copy
recording
Yes
Yes
(destination)
No
Yes (original)
Remove the terminal
cover.
1
Make sure that the power of the
unit is turned off.
Set the main power switch on the right side of
the unit to "O (off)." (MPS-VS500P)
Make sure that the VIEWER ON/OFF key
indicator lights in red. If the indicator lights in
green, press the VIEWER ON/OFF key to turn it
to red. (MPS-VS500)
2
Set the viewer to the
compartment.
Place the viewer so that the protruding area on the
unit fits on the battery compartment located on the
rear of the viewer. Press the viewer down lightly
until the LOCK knob clicks and shifts to the left.
3
Slide the LOCK knob fully to the
left.
The RELEASE button protrudes and the viewer
is locked onto the unit.
4
Set the main power switch to "I
(on)" (MPS-VS500P only), and
press the VIEWER ON/OFF key.
The VIEWER ON/OFF key indicator turns from
red to green, and the unit and the viewers are
turned on. The viewer screen lights up.
You can operate the viewer with its keys. (See
the operating instructions of the viewer for
details on its operation.)
LOCK knob
RELEASE button