Preparing Cappuccino And Latte Macchiato - WMF 10 Manuel D'utilisation

Operation
If you wish to set the cup volume to the maximum value, do not press the button again. The coffee
dispensing stops automatically at the maximum quantity. The illuminated cross then flashes white 3
times to confirm successful programming.
The program is now fixed until it is changed or reset to the standard quantity.
>
Turn the locking knob back to the home position
Ending preparation
>
After brewing, remove the used coffee pads or the ground coffee cassette from the pad cassette.
Clean the ground coffee cassette under running water after use.
3.3.4
You will be able to make these coffee specialities even better if you use coffee softpads with an espresso
powder.
>
Place a cup centrally below the spouts for coffee and milk foam.
One cup
>
Fill the milk container with cold milk, place it on the right of the appliance and insert the milk hose
into it.
>
Wait until the illuminated cross glows white.
To be able to prepare milk foam, the steam generator must first be heated.
>
To do so, press the cappuccino or latte macchiato button.
During heating, the illuminated cross glows red. As soon as the steam generator is ready, the illuminated
cross pulses white and the preparation starts immediately.
Foamed milk and coffee are poured into the cup. In the case of latte macchiato, the coffee follows only
after a pause of 20 seconds. During this time, the milk foam can settle down to achieve optimum layering.
19

Preparing cappuccino and latte macchiato

, as soon as fluid stops coming out.