Installing Wall Brackets & Back Beam - NewAge Products Pro Serie Mode D'emploi

Installing Wall Brackets & Back Beam
Start installation with the middle
3
hanging bracket.
Align the bottom of the Wall Mounting
Bracket (#6) with the bottom level line and
the center of the wall stud with the center
of the horizontal slot in the mounting
bracket (mark the hole to be drilled)
5 i
8ft Wide Wall Mounted Shelf: Insert two carriage bolts (#8) into the middle wall
mounting bracket. Secure wall mounting bracket to stud using one 3in Lag Screw (#24),
one 1/4" washer (#9) and 7/16" socket. Note: If connecting 2 or more Wall Mounted
Shelves horizontally, refer to pg 27 before installing bracket.
i
Masonry
• Follow steps 1 to 11.
• Drill pilot holes through the marked locations with hammer drill & 5/16" masonry bit.
• Use Concrete Anchor for each pilot hole.
4 Drill a pilot hole using a 3/16" drill bit.
Note: Pilot hole must bore into 3 inches
of solid wood for lag screw to be fully
secured.
Warning:
Make sure the Lag Screws
are tight against the stud
but DO NOT over-tighten
the lag screws.
If lag screws are over-
tightened, the lag screw
could snap or the hole
may be stripped.
13