Connecting Wall Mounted Shelves Horizontally
Install first wall shelf according to
1
option A (Wall Mounted) or B (Ceiling
Mounted), until reaching Step 12 on
page 16 or page 18.
Insert a 5/16" Hex Bolt into the Front/First hole of the side perimeter beams. Slide Pully cable cap
3
onto the Hex Bolt and wrap the Cable Assembly around the pulley. Slide the Pulley Cable Cap onto
the Hex Bolt and secure with a 5/16" lock nut. Align tab on Pulley Cable Cap with cutout in side
frame.
Note:
Only one cable assembly is required for each pair of side perimeter beams.
Attach Side Beams by guiding the
4
mounting holes into the carriage bolts and
shoulder rivets on the wall bracket. Then
bolt the side perimeter beams with a 1/4"
washer and 1/4" acorn nut.
Once the connecting side beams have
5
been installed, continue installation with
step 17 on page 20.
Note: Before installing the Wall
2
Mounting Brackets, ensure wall
mounted bracket will be shared
between two shelves that both carriage
bolts are mounted where there will be
two Wall Mounted Shelves connected.
27