Mobicool A40 Notice D'utilisation page 13

A40
Connecting to 12 Vg
I
NOTE
 You cannot set the temperature with the thermostat control
during battery operation. The device is simply switched on
and starts cooling.
 Disconnect the cooler from the battery when the engine is not
running as otherwise the battery will be completely run down.
➤ Make sure that the cable from the battery to the cooler is protected by
a fuse (max. 8 A).
➤ Select a cable cross section for the cable between the battery and the
socket of the 12 V voltage supply in accordance with the following table:
Cable length
Up to 2.5 m
2.5 m to 4.0 m
➤ Make sure that the thermostat control for 220 V – 240 V operation
(fig. 2 2, page 3) is in the "0" position.
➤ Insert the plug of the connection cable into the 12 V socket
(e.g. cigarette lighter).
The polarity cannot be reversed.
➤ To switch off the cooler, pull the plug out of the socket.
Connecting to a gas source
!
WARNING!
 The operation of gas appliances whilst the vehicle is in motion
must be in accordance with national guidelines.
 Only use propane or butane gas cylinders with an approved
pressure reduction valve and suitable top part.
 Compare the pressure information on the type plate with the
pressure information on the propane or butane gas cylinder.
 Never place the device near flammable materials (paper, dry
leaves, textiles).
 Your connecting hose must be replaced in accordance with
national guidelines.
 Only use approved hose lines (DIN 4815 part 2) with a maxi-
mum length of 1.5 m (in Finland 1.2 m).
EN
All manuals and user guides at all-guides.com
Cable cross section
2.5 mm²
4.0 mm²
Operating the cooler
13