Electrical Connections - V2 STERN600 Instructions De Montage

3.3 - ELECTRICAL CONNECTIONS

1. Open the cover by loosening the screw (fig. 24) and pushing
the button (fig. 25).
2. Remove the small disc [S] with a screwdriver (fig. 26).
3. Feed the cables through the hole [S] (fig. 27).
4. Refer to fig. 28 and the connection descriptions in table when
making the connections. If using the flashing light aerial,
remove the wire clip (connected to terminal 14 as standard)
and connect the RG58 shielded cable.
5. Once you have connected up all the cables, secure them using
cable clips.
6. To close the cover, push it back into place, making sure you
hear a "click". Reinsert and tighten the screw to finish.
FIG. 24
FIG. 25
FIG. 26
FIG. 27
S
- 33 -