24Vdc Accessories' Power Supply; Wired Commands; Antenna - V2 STERN600 Instructions De Montage

10.6 - 24VDC ACCESSORIES' POWER SUPPLY

TERMINALS: 8-5, 10-5
Nominal voltage 24V , max. 10W, output for powering external
accessories as photocells, radio receivers, etc.
Real voltage output can be greater than nominal value, check the
compatibility of external accessories.

10.7 - WIRED COMMANDS

START CONTACT
The "START" input (terminals 7-8) is a normally open gate
activation command by wire.
The activation method is set up by dip switches 1 and 2 - see
Paragraph 4.1.
This input is a voltage free (dry contact) only. Connecting power
to this input will void warranty.
m
TIMER FUNCTION: if START contact is kept closed
(for instance through a timer-controlled or bistable relay),
control unit opens the gate and leaves the gate opened.
The automation does not accept closing commands (neither
automatic nor wired) until START contact is reopened.
In this mode, dip switch 1 STEP is set to OFF and dip 2 AUTO
to ON to ensure that the gate never remains locked open.
m
If multiple START contacts are connected, connect the
contacts in parallel.
m
If START contact is kept closed during the control unit
starting after a blackout, the gate will immediately execute
the start command.
STOP CONTACT
The "STOP" input (terminals 6-8) is for immediately stopping and
locking any movement of the gate.
This input is a normally closed and voltage free (dry contact) only.
m
Connecting power to this input will void warranty.
To restore operation this contact must be closed.

10.8 - ANTENNA

TERMINALS: 13-14.
Antenna terminal for transmitter signal reception. A wire is factory
connected to this terminal.
For extending the reception range, an external antenna can be
connected.
m
If an external antenna is connected, the series
connected wire must be disconnected.
- 41 -