Sony SU-PF3M Mode D'emploi page 6

Assembling the Floating
Stand
WARNING
If you allow the mains lead to be pinched under or
between pieces of equipment, this may result in a
short circuit or an electric shock.
If you stumble over the mains lead or the
connecting cable, the stand may topple over and
cause injury.
Decide on the installation location and lay the
stand down before installing the TV.
Since the TV is heavy, it is recommended that you
decide on the installation location and lay the
Floating Stand down before installing the TV.
Note
Do not push or pull the Floating Stand while it is on the
floor. The rubber footings on the base of the Floating
Stand may come off.
6
(GB)
1
Detach the cable covers.
1 Pull out the cable covers for the rear side of
the TV from the Floating Stand.
2 Detach the cable covers for the pillars of the
Floating Stand.
2
Position the rear panel on the
pillars and secure on each side
with the supplied rear panel
securing screws.
1
Cable cover for
rear side of the
TV
2
Cable cover for
the pillars
Slide your finger
into the hole at the
bottom of the
Floating Stand and
detach the cable
cover.