Manual Reset - TRADINGZONE SMARTLINE STESI Instructions De Montage Et D'utilisation

ASSEMBLY & FIRST START-UP. MANUAL CONTROL GENERAL
"LIGHT" MANUAL CONTROL

MANUAL RESET

When the desk is used for the first time a reset must be done before you can operate the product. The reset causes all of the
columns to be brought to the same level. This ensures that the table top is positioned parallel with the ground. The controller
also saves the connected components in the standard configuration, such as columns or a sensor, if there is one attached. After
the reset, changes to the configuration are detected and considered to be errors. The system will not operate until the configura-
tion stored in its memory has been re-established.
2.1 Simultaneously press and hold down the "lower table top" and "raise table top" buttons.
After around 5 seconds the table will move towards the centre, remain there and complete the reset.
2.2. Release the button(s). The electrically height-adjustable workstation can now be used again normally.
Attention: Reset point is at table height 101 cm. The safety shutdown is out of operation upon a reset!
Raise table top Lower table top
32