Solution - TRADINGZONE SMARTLINE STESI Instructions De Montage Et D'utilisation

SOLUTION. CLICK CODES
As soon as the controller is supplied with power, the controller uses its built-in relays to audibly inform the user about the
system status. The following table shows the correlation between the number of clicks and what they mean.
NUMBER OF CLICKS
2x close together
(quick double-click)
2x far apart
(slow double-click)
3x close together
(quick triple-click)
3x far apart
(slow triple-click)
Note: The click codes produced when saving memory positions or saving/deleting pedestal- and shelf-stop positions are
described in the relevant sections.
STATUS INFORMATION
Normal operating mode:
The system is working properly. The signal is only produced right after the
controller is supplied with power.
Reset mode:
The system is currently in reset mode.
This signal is always produced when the table should not be lowered in the
reset direction
(up button and/or memory buttons)
Sensor missing:
The crush protection sensor is not connected to the controller.
This signal is always produced when the table is to be moved
(up/down button and/or memory buttons)
Maximum allowable operation time reached:
This signal is always produced when the table is to be lowered (down button)
35