Features - TRADINGZONE SMARTLINE STESI Instructions De Montage Et D'utilisation

FEATURES. PEDESTAL-STOP – SHELF-STOP
These two features can be used to limit the table's range
of movement (e.g. if a pedestal is located under the table).
A pedestal-stop position can be set in the lower half of the
range of movement, and a shelf-stop position can be set in
the upper half (this is also to be followed by deactivation). If
a pedestal-stop position is set, this is used as a new lower end
position; a shelf-stop position corresponds to a new upper end
position for the range of movement. To save a pedestal-stop or
shelf-stop position, do the following.
ACTIVATE POSITION
1. Position the table top where you want to set the new
pedestal-stop or shelf-stop position. Use the "lower table
position" or "raise table position" buttons to maneuver the
table into position.
2. Press at the same time briefly the "lower table position"
and "raise table position".
3. Within 5 seconds, press the "raise table position" button
and hold it for at least 5 seconds.
An audible double-click in the motor
control indicates that the pedestal-stop or
shelf-stop position has been successfully
saved.
33