TRADINGZONE SMARTLINE STESI Instructions De Montage Et D'utilisation page 37

SOLUTION. POSSIBLE PROBLEMS
LIFT DESK. POSSIBLE PROBLEMS
Error Pt.
3.1
TABLE ONLY TRAVELS
WITH ONE COLUMN
3.2
4.1
TABLE ONLY MOVES A LIMITED
DISTANCE AND MOVES 5 CM IN
4.2
THE OPPOSITE DIRECTION
(COLLISION PROTECTION ACTIVE)
4.3
5.1
TABLE ONLY TRAVELS
A LIMITED PATH
5.2
Action 1
Disconnect power plug
Connect/check motor cable
Connect power plug
Click code audible
Reset system
Disconnect power plug
Connect replacement manual control Pro
Connect power plug
Reset controller to factory setting
and reset system
Remove obstacles from path of travel
Eliminate tension by raising
the table on one side
Column is roll resistant and
needs to be exchanged
Deactivate or adjust container/shelf-stop
Overload on motor (table travelled to
obstacle, table is massively overloaded
Remove obstacle, reduce load
Result 1 Problem
Table works pro- Motor cable was
perly incorrectly connected
Motor cable was incor-
Table works pro-
rectly connected before
perly
start-up
Table works pro- Obstacles in the path of
perly travel
Table works pro- The table frame
perly was under tension
Table works pro-
perly
Table works pro- Container/shelf-stop was
perly activated
Table travelled to obsta-
Table works pro-
cle, table is massively
perly
overloaded
Action 2 Result 2
Error message:
Action according to error message
...................
Connect replacement Manual con-
Error message:
trol switch Pro
...................
Action according to error message