How To Prepare The Machine For Operation; How To Install The Batteries - Clarke BOOST 32 Manuel De L'utilisateur

HOW TO PREPARE THE MACHINE
FOR OPERATION

How To Install The Batteries

This machine uses four 6-volt batteries. The batteries
are located in the battery compartment under the
recovery tank.
To Install the batteries, follow this procedure:
1. Turn key switch off.
2. Make sure both tanks are empty.
3. Disconnect the hoses from the recovery tank
(upper tank) & unplug the vac motor and float
switch.
4. Remove the tank support bracket.
5. Remove the recovery tank.
6. Place the batteries in the solution tank as
shown in figure 6a or 6b.
WARNING: Lifting batteries without
help could result in an
injury. Get help to lift the
batteries. The batteries are
heavy.
WARNING: Working with batteries can
be dangerous. Always
wear eye protection and
protective clothing when
working near batteries.
NO SMOKING!
7. Connect the battery cables between
batteries and install long battery cable
assembly as indicated. See figure 6a or 6b.
8. Install the tank, reconnecting hoses and
plugging in vac motor and float switch
connectors. Install tank support bracket.
NOTE: Charge the batteries before using the
machine.
NOTE: Check battery water levels prior to use.
®
Clarke
Operator's Manual (EN) - BOOST 32
ENGLISH
EN
Figure 6a
Figure 6b
- 11 -