Clarke BOOST 32 Manuel De L'utilisateur page 20

ENGLISH
EN
MAINTENANCE
These Maintenance Procedures Must Be Done Every
Week:
WARNING: Maintenance and repairs must be
done by authorized personnel only.
Always empty the solution tank and
the recovery tank before doing any
maintenance.
tight.
WARNING: Always wear eye protection and pro-
tective clothing when working near
batteries. Do not put tools or other
metal objects across the battery ter-
minals or the tops of the batteries.
CAUTION: To prevent damage to the machine,
and discharge across the tops of the
batteries, do not fill the batteries
above the bottom of the tube in each
cell. Wipe any acid from the ma-
chine or the tops of the batteries. Do
not add acid to battery after installa-
tion.
NOTE: Always turn off key switch before servicing the
machine.
WARNING: Always wear eye protection and
protective clothing when working
near batteries. NO SMOKING!
1. To inspect batteries, tip up recovery tank until it locks
in up position. See Figure 24.
2. Disconnect the batteries. Use a cloth and a solution
of ammonia or bicarbonate of soda to wipe the top of the
batteries. Clean the battery terminals. Reconnect the
batteries.
3. Check the hoses for leaks, obstructions and other
damages.
4. Check and clean the filter screen in-line with the
solution hose. To clean the screen, follow this proce-
dure:
a. Turn the solution vavle to the off position.
b. Remove and clean the filter screen.
c. Install the filter screen. Turn on the solution
valve.
5. Use a grease gun to lubricate the drive wheel and the
casters. See figure 25.
6. Check tire pressure. Tire pressure should be about 50
psi.
Page -20-
Keep all fasteners
Figure 24
Figure 25
®
Clarke
Operator's Manual (EN) - BOOST 32