Maintenance - Clarke BOOST 32 Manuel De L'utilisateur

ENGLISH
EN
HOW TO OPERATE THE MACHINE
How to Clean a Very Dirty Floor
To clean a very dirty floor, follow this procedure:
1. Apply solution to the floor.
2. Do not lower the squeegee.
3. Do not activate the vacuum motor.
4. Lower the brush or pad and scrub the floor.
5. Leave the solution on the floor long enough for the
solution to begin cleaning the floor.
6. Scrub the floor again with additional solution, picking
up all the solution with the squeegee

MAINTENANCE

WARNING: Maintenance and repairs must be done
by authorized personnel only.
WARNING: Always empty the solution tank and
recovery tank before doing any mainte-
nance.
WARNING: Keep all fasteners tight.
These Maintenance Procedures Must Be Done Every Day
Keep the machine clean, it will need fewer repairs and have
longer life.
Do These Procedures When You Begin Your Work
Period
1. Turn off key switch.
2. Machines with on-board chargers -
Unplug charger from AC outlet and wrap cord around
bracket at rear of machine.
3. Machines equipped with remote chargers -
disconnect the plug on the battery charger and the
battery pack connector. Join the connector from the
batteries to the machine cable connector.
4. Make sure the recovery tank lid is on correctly (see figure
20).
5. Make sure the Screen filter over the vacuum motor is
clean and in position (see figure 20).
6. Make sure the valve on the recovery drain hose is clean.
Tightly close the valve.
7. Make sure the brush or pad is in position and
installed correctly
8. Check the installation of the squeegee and
squeegee hose.
Page -18-
Figure 20
®
Clarke
Operator's Manual (EN) - BOOST 32