Cleaning The Shaver; Cleaning With The Brush - Panasonic ES-LV6Q Mode D'emploi

Cleaning the shaver

We recommend cleaning the shaver after each use.
Cleaning with water
• Turn the shaver off and disconnect the AC adaptor.
1
Apply some hand soap and some
water to the system outer foil�
2
Press for more than
2 seconds to activate the sonic
vibration cleaning mode�
• Splashing of foam is suppressed.
• The battery capacity lamps blink in order.
• After about 20 seconds, it will be
automatically turned off, or you can turn
it off by pressing the power switch.
3
Remove the outer foil section
and clean with running water�
• See page 14 for attaching and
removing the outer foil section.
• Splashing is reduced by rinsing the
shaver in sonic vibration cleaning mode.
• After rinsing with water, shake the shaver up and down for a
few times to remove excess moisture and then wipe off any
drops of water with a dry cloth.
ES-LV6Q_US.indb 13
4
Dry the outer foil section, the
shaver, and the trimmer
completely�
• Allow the shaver to dry in the shade,
avoid direct sunlight.
5
Lubricate the shaver�
It will keep the movement of the blade
smooth and maintain a comfort shave.
1. Apply one drop of oil to each of the
system outer foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately fi ve seconds.
4. Switch off the shaver, and wipe off any excess oil from the
system outer foil with a soft cloth.
Notes
• Be careful not to hit the main body on the sink or any other object
while draining the water. Failure to do so may cause malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, or cracking or discoloration of
the parts.
Wipe with diluted soapy water.
• Do not use any kitchen or bathroom detergents other than hand
soap.
Doing so may cause malfunction.

Cleaning with the brush

Remove the outer foil section and the inner blades.
(See page 14.)
13
2018/03/02 15:53:09