Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cleaning the shaver
1
2
1
1
1
Insert the appliance
plug.
2
2
Plug in the adaptor.
Remove any soap or water on
•
the shaver if it has been
washed with hand soap or
any other detergent.
Course selection indications
On recharger
Course
CLEAN
DRY
1Charge
2 Clean/Dry/
Charge
3Clean/Dry
4Dry/Charge
5Dry
*The lamp goes out in 6 seconds.
8
3
3
Remove the
protective cap and
then attach the
shaver.
Turn the shaver off before
•
attaching.
Check that the outer foil is not
•
deformed or damaged when
you are attaching the shaver.
Changeable course
halfway through
CHARGE
*
2345
3
2
235
234
SELECT
CLEAN
DRY
CHARGE
STATUS
4
4
Press [SELECT] to select the course.
Each time you press [SELECT], the course changes from "Clean/
•
Dry/Charge" "Clean/Dry" "Dry/Charge" "Dry" "Charge".
The courses start approximately 6 seconds after they are
•
selected.
The course will be aborted if the power is cut off. In this case,
•
perform the course again from the beginning.
Do not detach the detergent cartridge or the water tank as the
•
cleaning liquid may spill causing a malfunction.
Course completion summary
On shaver
On recharger
CLEAN
DRY
Glows
Glows while
charging
–
Glows while
charging
–
Time required
On shaver
(guide) [In the low
CHARGE
temperature]
Blinks
1 hour
Blinks
2 hours [+30 min]
–
1 hour [+30 min]
Blinks
2 h 40 min
–
1 h 40 min
Publicité
Table des Matières
