Cleaning the shaver
1
2
1
1
1
Insert the appliance
plug.
2
2
Plug in the adaptor.
Remove any soap or water on
•
the shaver if it has been
washed with hand soap or
any other detergent.
Course selection indications
On recharger
Course
clean
dry
1Charge
2 Clean/Dry/
Charge
3Clean/Dry
4Dry/Charge
5Dry
*The lamp goes out in 6 seconds.
8
5
4
3
3
3
Pull up the arm.
4
4
Remove the protective
cap and then attach the
shaver.
Turn the shaver off before attaching.
•
Check that the outer foil is not
•
deformed or damaged when you are
attaching the shaver.
5
5
Push down the arm.
Changeable course
halfway through
charge
*
2345
3
2
235
234
6
6
Press [select] to select the course.
Each time you press [select], the course changes from
•
"Clean/Dry/Charge" "Clean/Dry" "Dry/Charge"
"Dry" "Charge".
The courses start approximately 6 seconds after they are
•
selected.
The course will be aborted if the power is cut off. In this
•
case, perform the course again from the beginning.
Do not detach the detergent cartridge or the water tank as
•
the cleaning liquid may spill causing a malfunction.
Course completion summary
On shaver
On recharger
clean
dry
Glows
Glows while
charging
–
Glows while
charging
–
On shaver
Time required
(guide)
charge
Blinks
1 hour
Blinks
4 h 30 min
–
3 hours
Blinks
4 h 0 min
–
h 50 min