Electrical Connections; General Information - France Air ECM Notice Technique

5. ELECTRICAL CONNECTIONS

5.1. GENERAL INFORMATION

The electrical connection must be performed by a qualified electrician.
The electrical installation must be equipped with a circuit breaker.
The electrical connection of the MODULYS® ECM unit must be made via the local switch, which is fitted
on the product and wired.
The device must be connected via a rigid, insulated and temperature-resistant cable, with a diameter
corresponding to current standards and regulations.
Connection procedure:
- Cut the power supply, making sure that it cannot be accidentally restored.
- Position the switch to Off.
- Unlock the front access door by a quarter-turn. Angle the door outward to
remove it
- Remove the screw guards from the switch panel, and unscrew the panel.
Make the connection to the local switch as shown below
48 ______________________________________________________________ NT 1963 E – 07/2020
L1 L2 L3 PE