France Air ECM Notice Technique page 45

If necessary, the intake or supply air panel can be removed to enable the ancillary module to be fitted.
Fit the seal supplied with the ancillary module to ensure the sealing of the assembly.
4.9.2. CHANGING FROM A HORIZONTAL DISCHARGE TO A VERTICAL DISCHARGE
Procedure:
4- Unscrew the M6X30 screws from the following plates
a. Vertical discharge take-off plate
b. Horizontal blanking plate
5- Using the M6X30 screws, screw the blanking plate in the vertical position in place of the take-
off plate
6- Using the M6X30 screws, screw the take-off plate on the discharge, in the horizontal position.
NT 1963 E – 07/2020 _______________________________________________________________ 45