Safety And Recommended Tools; Safety Instructions - SDCEM MR41E Notice D'installation Et De Maintenance

SAFETY INSTRuCTIONS

Maintenance operations must be carried out by persons possessing:
• the necessary electrical accreditation,
• knowledge of the equipment in question.
Some maintenance operations must be carried out by SDCEM technicians, who can also
provide you with assistance in assembly and adjustment of your installations. Please contact
SDCEM Services for all queries (contact details on the last page of this Instruction Book).
DANGER: Electrocution, burn and explosion hazards
The installation concerned by the operation must be de-energised prior to operation.
Electrocution, burn, explosion, finger squeezing, cut-offs (handling, operations, etc.) hazards are
present at each operation.
Only qualified persons, complying with all safety regulations, are accredited to perform such
operations.
Safety and operation instructions, personal protective equipment, tools
and signalling
Refer to local regulations and legislation.
RECOMMENDED TOOLS (Not supplied by SDCEM)
• Adjustable spanner (600 long)
• End wrenches: dimensions 7 to 30
• Pipe wrenches: dimensions 7 to 30
• Set of male hexagonal wrenches
• Torque wrench, set of sockets
• Tongue and groove pliers
• Set of screwdrivers
• Plastic end mallet
• vice-grip pliers or clamps
• Steel tube cutter (21-60 dimension)
• Steel drill and drill bits
• Fold-out insulating rule
• Rule
INTRODuCTION

Safety and recommended tools

• Spirit level
• 45°, 90° square or protractor
• Fine-tipped felt pen
• Multimeter
• Set of electrician's screwdrivers
• "Scotch brite" type pad
• Contact grease: ISOFLEX TOPAS NB152
• Multifunction grease: MOLYKOTE BR-2 PLuS
• Cold galvanisation aerosol
• Brushes
• "Glass and surfaces" cleaning agent
• Cleaning cloth
Electrical
accreditation :
Recognition of a person's
ability to safely carry out
the tasks assigned to him/
her.
The accreditation
category specifies its
scope and limits
Operating mechanism
NTI010hA
type MR41E
PAGE
04