Installation Of Window Sealing Accessories - OPTIMEO OPC-A01-160HP Manuel D'utilisation

bags;
2 insert the heat pipe assembly (the end of the exhaust joint) into the back panel vent slot (push
to the
left) and complete the assembly (as shown in figure 1).

2. Installation of window sealing accessories

There are two options to seal the window for better exhaust of hot air
Window plate for sliding windows
Half open the window and mount the window sealing plate assembly to the window (as shown
in Fig.2 and Fig.3).Components can be placed in horizontal and vertical direction.
Pull various components of the window sealing plate assembly open, adjust their opening
distance to bring
both ends of the assembly into contact with the window frame, and fix various components of
the assembly.1.2 Install the window sealing plate assembly
Notes: 1) The flat end of the exhaust pipe joints must be snapped into place.
2) The pipe cannot be distorted nor has substantial turning (greater than 45 °). Keep the
ventilation of the exhaust pipe unblocked.
Figure 2 Figure 3
Move the unit with installed heat pipe and fittings before the window, and the distance between
the body and walls or other objects shall be least 50 cm (as shown in Fig.4).
Figure4
12