Audible System Signals - Accu-Turn 1220 Manuel De L'opérateur

4.1-1
16
All manuals and user guides at all-guides.com
Layout
4.1
Refer to Figure 4.1-1.
Note:
1.
As the corrective weight position on the wheel
reaches 12:00, all weight application position (WAP)
indicator lights will illuminate confirming that you
have located the position for weight application. All
weights will be applied at 12:00 with all WAP lights
illuminated.
2.
Depending on the stage of the program the display
gives the operator information about rim sizes, bal-
ancing weights, error codes, etc.
3,7
Fit a clip-on weight at the rim position indicated when
the relative WAP indicator lights up.
4,5,6
Fit a stick-on weight at the rim position indicated
when the relative WAP indicator lights up.
8
The indicator lights up when you activate the mo-
torcycle wheel balancing program or the single
weight (static mode).
9
The indicator lights up when you activate the PAX
SYSTEM wheel balancing mode.
4.1.1
Possible beeps:
High:
the unit returns a short high beep at the start of the
balancing cycle. or after activating a key. Refer to
Chapter 4.2.
Low:
the unit returns a low beep if an error is detected,
usually together with a system message indicating
the nature of the error.
For all other audible beeps, refer to Chapter 7, as these
indicate errors.
Operator's Manual
The display.
Positions related to the internal (left) plane
of the wheel are labeled with a number
followed by "a", while for external (right)
plane positions the number is followed by
"b" (e.g.: 1a, 1b).
Weight Application Position (WAP) indicator.
Display.
Weight position indicator.
Weight position indicator.
Motorcycle Dynamic and Static Indicator.
PAX wheel Indicator.

Audible System signals.

ACCU 1220