Static 1 Balancing Mode; Static 2 Balancing Mode; Motorcycle Static Balancing Mode; Pax Wheel Balancing Mode - Accu-Turn 1220 Manuel De L'opérateur

5.3.2.4-1
5.3.2.5-1
5.3.2.6-1
5.3.2.7-1
40
All manuals and user guides at all-guides.com
Operations
5.3.2.4
Only static imbalances are measured and corrected.
When selected, the display appears as shown in Figure
5.3.2.4-1.
• After entering the dimensions (Chapter 5.3.1), spin
the wheel.
• Apply the clip-on weight at the 12 o'clock position.
• Perform a check spin when done.
5.3.2.5
Only static unbalance is measured and corrected here.
When selected, the display appears as in Figure
5.3.2.5-1.
• Enter the dimensions (see chapter 5.3.1) and spin
the wheel.
• Apply the adhesive weight to the 12 o'clock position.
Ideally, this weight is applied on the rim median, so
as not to provoke dynamic unbalances.
When finished, perform a check spin.
5.3.2.6
Install the motorcycle rapid flange as indicated in
Chapter 5.1 and insert the Offset reader extension.
This mode allows you to measure and correct wheel
static imbalances only.
When selected, the display appears as shown in Figure
5.3.2.6-1.
• Enter the dimensions (Chapter 5.3.1) and spin the
wheel.
• Apply the stick-on or clip-on weight (on the spokes)
in the 12 o'clock position.
• Perform a check spin when done.
5.3.2.7
PAX SYSTEM wheels can be balanced with this
function (see Figure 5.3.2.7-1). When the PAX
function is on, the display is set for dimensions to
be entered in mm as required by this type of wheel.
• •
indicated for ALU4 wheels.
Operator's Manual

Static 1 balancing mode.

Static 2 balancing mode.

Motorcycle Static Balancing Mode.

PAX wheel balancing mode.

Follow the operative instructions previously
ACCU 1220